top of page
3D Scanning and Printing
3D Scanning and Printing
Surface Dirt and dust was removed using dry cleaning methods such as soft brushes and a museum vacuum on low suction with a net guard covering the nozzle.
This was followed by wet cleaning the surface of the pediment with Tri-Ammonium Citrate 2% in distilled water as it was the most affective in removing the engrained dirt and did not affect the state of the oil gilding. Acetone was used to treat the water gilding.
Surface Dirt and dust was removed using dry cleaning methods such as soft brushes and a museum vacuum on low suction with a net guard covering the nozzle.
This was followed by wet cleaning the surface of the pediment with Tri-Ammonium Citrate 2% in distilled water as it was the most affective in removing the engrained dirt and did not affect the state of the oil gilding. Acetone was used to treat the water gilding.
Once the gesso had dried it was then sanded down to make it smooth, level and matched the original appearance of the corner
_JPG.jpg)
_JPG.jpg)
bottom of page